+49 8193 - 93 92 90
+49 8193 - 93 92 90
The tubes are produced in various materials using a cold drawing method.
Waveguide sizes and corresponding frequency ranges are set out in the table: Waveguide size/range
The tubes can be supplied in any length up to 3 m.
Waveguide tubes offer minimum loss signal transfer at high frequencies and high power levels.
Standard components work with up to 325 GHz. At higher frequencies (up to 600 GHz) specialist waveguide tubes must be used (e.g. tube material = silver).
In order to avoid arcing effects in air-filled waveguides at high power levels, the tubing system may have to be pressurized. Nevertheless, waveguide tubes are also successfully operated at near-vacuum conditions by research facilities (e.g. in plasma physics or on satellites).
For physical/technical background information on waveguides visit:
http://www.radartutorial.de/03.linetheory/Hohlleiter.de.html
Traditional and high-end waveguide components. In an existing design approach, customized or even new design solutions - we support any of your specific development or qualification project.
We also supply a huge variety of passive and active coax components.
For each and every one of these items MIWEKO delivers off-the-shelf products in the shortest time possible, or provides full customization support, where needed.
The instruments category includes all components used for measuring, monitoring, recording, analyzing and issuing notifications on any RF or microwave system or sub-system.
New cable series MWX6 of Junkosha with accurate skew match (less than 1psec at e.g. 67GHz between cable pairs).
For robust transmission of sensitive signals by e ...
› read more
Analog Microwave Design (AMD) has developed a new SMD-Bandpassfilter for 10,3 GHz
Fc: 10,3 GHz
BW: 400 MHz
Mtron PTI enters with new Low Phase Noise OCXO into the market
MIWEKO | Münchener Straße 21 | 86949 Windach | +49 8193 - 93 92 90 | info@miweko.de
© 2015 MIWEKO - All rights reserved | Imprint | Privacy | General terms and conditions
