+49 8193 - 93 92 90

Bends (cast/swept)

The application of a separate bend is necessary if a waveguide run cannot or should not be realized as a single run due to mechanical or economic constraints.
In general a bend can be realized directly inside, or at the end of a straight waveguide run, but it might be more appropriate to realize it as a separate component to be assembled in the run.
If e.g. the run is too complex to be preassembled outside its final installation environment, and mechanical mating interfaces need to be defined, a bend is a good solution and enables step-by-step installation.
Where financial restrictions apply, it might be more cost-effective to install different waveguide run components (in this case bends) rather than designing them directly into a single run.
Bends are available in almost all types of flange (even a mixed flange configuration would not be a problem). If you have to bridge a large bending radius, to a greater or lesser degree, and large dimensions, swept bends are the appropriate choice. If your bending is close to an "edge", perhaps cast bends would be more appropriate. Moreover, it can sometimes be more cost-effective to select cast bends as they are easier to manufacture with a very small radius, and they are available as off-the-shelf products, which is also an advantage in terms of the delivery time.

 

Waveguide Components

Traditional and high-end waveguide components. In an existing design approach, customized or even new design solutions - we support any of your specific development or qualification project.

waveguide Portfolio

RF Components

We also supply a huge variety of passive and active coax components.
For each and every one of these items MIWEKO delivers off-the-shelf products in the shortest time possible, or provides full customization support, where needed.

RF-Portfolio

Instruments

The instruments category includes all components used for measuring, monitoring, recording, analyzing and issuing notifications on any RF or microwave system or sub-system.

instruments-portfolio

Medical technology

Transmitter and receiver stations

EMC

Satellite communications

Mobile communications

Radar technology

Defense technology

Measurement technology

MIWEKO Actuals

New Partnership for EMC

In 2019 MIWEKO launched a close strategic partnership with our partner rflight and beCom.

This cooperation aims to all aspects in the technology segment EMC syst ...
› read more

Junflon MWX6 Series

New cable series MWX6 of Junkosha with accurate skew match (less than 1psec at e.g. 67GHz between cable pairs).

For robust transmission of sensitive signals by e ...
› read more

SMD-Bandpassfilter 10,3 GHz

Analog Microwave Design (AMD) has developed a new SMD-Bandpassfilter for 10,3 GHz

Fc: 10,3 GHz

BW: 400 MHz


› read more

MIWEKO | Münchener Straße 21 | 86949 Windach | +49 8193 - 93 92 90 | info@miweko.de

© 2015 MIWEKO - All rights reserved  |  Imprint  |  Privacy  |  General terms and conditions

Cookies make it easier for us to provide you with our services. With the usage of our services you permit us to use cookies.